INSPECTION PROCEDURE
PROCEDURE
1. CHECK DTC OUTPUT (C1AED)
(a) Check for DTCs See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Intuitive Parking Assist System.
(b) Clear the DTCs See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Intuitive Parking Assist System.
(c) Recheck for DTCs See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Intuitive Parking Assist System.
Result:
C -- USE SIMULATION METHOD TO CHECK See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting
B -- CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - REAR RIGHT SENSOR)
A -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - REAR RIGHT SENSOR)
(a) Disconnect the F52 connector from the clearance warning ECU.
(b) Disconnect the X1 connector from the No. 1 ultrasonic sensor.
(c) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment