Text in Illustration
HINT
Codes other than DTC B1830, B1831, B1832, B1833 and 57 may be output at this time, but they are not related to this check.
NG -- CHECK FLOOR WIRE (CURTAIN SHIELD SQUIB RH CIRCUIT)
OK -- REPLACE CURTAIN SHIELD AIRBAG ASSEMBLY RH See: Restraints and Safety Systems/Air Bag Systems/Air
Bag/Service and Repair/Removal and Replacement/Curtain Shield Airbag Assembly/Removal
1. CHECK FLOOR WIRE (CURTAIN SHIELD SQUIB RH CIRCUIT)
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Disconnect SST from connector C.
(d) Disconnect the floor wire from the center airbag sensor assembly.
(e) Check for a short to B+ in the circuit.
(1) Connect the cable to the negative (-) battery terminal.
(2) Turn the engine switch on (IG).
(3) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
(f) Check for an open in the circuit.
(1) Turn the engine switch off.
(2) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(3) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment