2010 Lexus Truck RX 350 AWD V6-3.5L (2GR-FE) U CODE Page 28

INSPECTION PROCEDURE

NOTICE:

Perform the universal trip to clear permanent DTCs See: Transmission and Drivetrain/Automatic

Transmission/Transaxle/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/U660F Automatic Transaxle

System/DTC Check / Clear.

HINT

* Refer to inspection procedure for CAN communication system.

* If the CAN communication malfunctions, the TCM cannot receive the current data from the ECM. In this case, the freeze

frame data output from the TCM has not been updated, so the data will not be useful for the inspection. However, reading the

Data List as the first step in troubleshooting is effective to find malfunctions.

* The malfunction area can be checked using the Bus Check function on the Techstream See: Powertrain

Management/Computers and Control Systems/Information Bus/Testing and Inspection/Initial Inspection and Diagnostic

Overview/CAN Communication System/Diagnosis System.

PROCEDURE

1. CHECK ECU TERMINAL VOLTAGE (+B AND E1 TERMINALS)

(a) Disconnect the TCM connector.

(b) Turn the engine switch on (IG).

(c) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

(d) Turn the engine switch off.

(e) Measure the resistance according to the value(s) in the table below.