(c) Start the engine.
(d) Drive the vehicle and turn the steering wheel to the right and left at a speed of 35 km/h (22 mph) or more.
(e) Check if the same DTC is recorded See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes.
Result:
HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next
step See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Symptom Related
Diagnostic Procedures/Problem Symptoms Table.
B -- REPLACE BRAKE ACTUATOR ASSEMBLY See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Hydraulic Control Assembly - Antilock Brakes/Service and Repair/Removal
A -- END
Up to 08/2009
MF1A TRANSFER / 4WD / AWD: ACTIVE TORQUE CONTROL 4WD SYSTEM: C1296: ABS Malfunction
DESCRIPTION
If a malfunction in the speed sensor signal circuit deceleration sensor circuit occurs, the 4WD control ECU will output this DTC.
INSPECTION PROCEDURE
HINT
Check the condition of each related circuit connector before troubleshooting See: Accessories and Optional Equipment/Antitheft
and Alarm Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/Electronic Circuit Inspection
Procedure.
PROCEDURE
1. CHECK FOR DTC
(a) Clear the DTC See: Transmission and Drivetrain/Transfer Case/Testing and Inspection/Reading and Clearing Diagnostic Trouble
Codes.
(b) Turn the engine switch off.
(c) Turn the engine switch on (IG) again.
(d) Drive the vehicle, accelerate to a speed of 20 km/h (12 mph) or more, and check if the speed sensor DTC (brake control system DTC)
No comments:
Post a Comment