2. CHECK REAR SEAT SIDE AIRBAG ASSEMBLY RH (REAR SIDE SQUIB RH)
(a) Connect the connector to the center airbag sensor assembly.
(b) Connect SST (resistance 2.1 Ohms) to connector C.
CAUTION:
Never connect the tester to the rear seat side airbag assembly RH (rear side squib RH) for measurement, as this may lead to a
serious injury due to airbag deployment.
NOTICE:
* Do not forcibly insert SST into the terminals of the connector when connecting.
* Insert SST straight into the terminals of the connector.
SST : 09843-18061
(c) Connect the cable to the negative (-) battery terminal.
(d) Turn the engine switch on (IG), and wait for at least 60 seconds.
(e) Clear the DTCs stored in the memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes/DTC Check / Clear.
(f) Turn the engine switch off.
(g) Turn the engine switch on (IG), and wait for at least 60 seconds.
(h) Check for DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
OK:
DTC B1850, B1851, B1852, B1853 or 62 is not output.
Text in Illustration
HINT
Codes other than DTC B1850, B1851, B1852, B1853 and 62 may be output at this time, but they are not related to this check.
NG -- CHECK FLOOR WIRE (REAR SIDE SQUIB RH CIRCUIT)
OK -- REPLACE REAR SEAT ASSEMBLY RH See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear
Seat Assembly (for RH Side)/Removal
3. CHECK FLOOR WIRE (REAR SIDE SQUIB RH CIRCUIT)
(a) Turn the engine switch off.
No comments:
Post a Comment