NG -- REPAIR OR REPLACE CAN MS BUS MAIN WIRE OR CONNECTOR (CAN NO. 6 J/C - MAIN BODY ECU)
OK -- REPLACE MULTIPLEX NETWORK BODY ECU (MAIN BODY ECU) See: Power and Ground Distribution/Power
Distribution Module/Service and Repair/Removal
12. CHECK FOR SHORT IN CAN MS BUS WIRES (TILT AND TELESCOPIC ECU)
(a) Disconnect the tilt and telescopic ECU connector.
Text in Illustration
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
HINT
It is only necessary to perform the inspection in the above table for the result (short circuit) that was obtained in the Check CAN
MS Bus Wire inspection.
Find the necessary inspection from the Purpose column that matches the result in the Result column from the Check CAN MS Bus
Wire inspection.
NG -- CHECK FOR SHORT IN CAN MS BUS WIRES (CAN NO. 6 J/C - TILT AND TELESCOPIC ECU)
OK -- REPLACE MULTIPLEX TILT AND TELESCOPIC ECU
13. CHECK FOR SHORT IN CAN MS BUS WIRES (CAN NO. 6 J/C - TILT AND TELESCOPIC ECU)
(a) Disconnect the CAN No. 6 junction connector.
No comments:
Post a Comment