INSPECTION PROCEDURE
PROCEDURE
1. CHECK DTC OUTPUT
(a) Clear the DTCs See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Rear View Monitor System (w/ Side Monitor System).
(b) Check for DTCs See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Rear View Monitor System (w/ Side Monitor System).
Result:
HINT
* If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when
rechecking for DTCs.
* If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection
again, even though the DTC was not output when rechecking for DTCs See: Accessories and Optional Equipment/Antitheft
and Alarm Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With
Troubleshooting.
B -- USE SIMULATION METHOD TO CHECK See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting
A -- GO TO CAN COMMUNICATION SYSTEM See: Powertrain Management/Computers and Control Systems/Information
Bus/Testing and Inspection/Initial Inspection and Diagnostic Overview/CAN Communication System/How to Proceed With
Troubleshooting
Up to 08/2009
NETWORKING: CAN COMMUNICATION SYSTEM: U0100: Lost Communication with ECM / PCM
U0100 - Lost Communication with ECM / PCM
No comments:
Post a Comment