Restraints - Seat Belt Extender Availability
2010 Lexus Truck RX 350 AWD V6-3.5L (2GR-FE) Page 352
L-SB-01 17-09
September 18, 2009
Seat Belt Extender
Service
Category Vehicle Interior
Section
Seat Belt
Market
USA
Applicability
Introduction
Lexus customers who find it necessary to increase the length of their seat belts may obtain Seat Belt Extenders at no cost through their local Lexus
dealer.
^ The extender is available in 6-inch, 9-inch, 12-inch, 15-inch, and 18-inch lengths.
^ The extender is available only in black.
^ Owners are informed of the Seat Belt Extender availability through the Lexus Owner's Manual included in each vehicle.
2010 Lexus Truck RX 350 AWD V6-3.5L (2GR-FE) Page 353
The customer (individual requiring the extender) must visit a Lexus dealership to have the required measurements made and to complete the Seat
Belt Extender Worksheet. The worksheet will allow the proper fitting and selection of a Seat Belt Extender for the customer. The dealership
personnel should then determine the applicable part number and place an order through Dealer Daily.
The dealership service department should complete the Seat Belt Extender Customer Information Label attached to the part and review the "Owner
Instructions" with the customer. The dealership should give a copy of the completed worksheet and Owner Instructions to the customer and keep the
originals in the customer's file. To assure utmost owner satisfaction, it is recommended that dealerships designate one person to coordinate all
activities related to the Seat Belt Extender issue. It is recommended that dealerships do NOT stock Seat Belt Extenders due to the need for proper
fitting to individual customers.
This bulletin contains the following information:
^ Procedure and Sample Label ^ Owner Instructions
^ Application Charts ^ Seat Belt Extender Worksheet
^ Part Number Information
2010 Lexus Truck RX 350 AWD V6-3.5L (2GR-FE) Page 354
Warranty Information
Ordering Procedure
1. Dealer verifies the need for a Seat Belt Extender and obtains a current copy of this TSIB and copies the worksheet.
2. Dealer measures the customer and completes the worksheet. Dealer determines the correct part number and places an order for the part through
Dealer Daily.
3. Dealer receives Seat Belt Extender and calls the customer to check the fit of the part.
4. If the Seat Belt Extender fit is good, dealership personnel completes the Customer Information Label attached to the part, explains usage of the
part, and gives the customer a copy of the completed worksheet.
5. Dealer places copy of the completed worksheet in the customer's records.
2010 Lexus Truck RX 350 AWD V6-3.5L (2GR-FE) Page 355
Front Seat Belt Extender Applications
Rear Seat Belt Extender Applications
The extender must NOT be used for the center rear seat belt except for the LX 570 which uses a K-8 extender.
Part Number Information
Owners Instructions
Failure to follow the recommendations indicated below could result in reduced effectiveness of the seat belt restraint system in case of vehicle
2010 Lexus Truck RX 350 AWD V6-3.5L (2GR-FE) Page 356
collision causing personal injury.
If your seat belt cannot be fastened securely because it is not long enough a personalized Seat Belt Extender is available from your Lexus dealer free
of charge.
Please visit your local Lexus dealer so that the dealer can order the proper required length extender.
Bring the heaviest coat you expect to wear for proper measurement and selection of length.
Additional ordering information is available at your Lexus dealer.
When the Seat Belt Extender is provided for rear seat positions (with automatic locking retractor) make sure the retractor is locked when in use.
To connect the extender to the seat belt, insert the tab into the seat belt buckle so that the buckle-release buttons of the extender and the seat belt are
both facing outward as shown in Figure 3.
You will hear a click when the tab locks into the buckle. When not in use, remove the extender and store in the vehicle for future use.
CAUTION
On vehicles equipped with SRS - Occupant Classification System (OCS)*, the extender tab should be buckled into the buckle AFTER the
occupant sits down in the seat.
Leaving extender installed in the buckle before sitting down will cause the OCS to be in the "airbag off" or disarmed state.
*OCS will enable or disable the passenger front and side airbags based on passenger weight and seat belt latch position classifying the passenger as a
child or adult.
CAUTION
When using the Seat Belt Extender, observe the following. Failure to follow these instructions could result in reduced effectiveness of the seat
belt restraint system in case of vehicle accident, increasing the possibility of personal injury.
^ NEVER use the Seat Belt Extender if you can COMFORTABLY fasten the seat belt without it.
^ The Seat Belt Extender must never be used with any child safety seats.
^ Remember that the extender provided for you may not be safe when used on a different vehicle, or for another person or at a different seating
No comments:
Post a Comment