(b) Make sure that there is no looseness at the locking part and the connecting part of the connectors.
(c) Disconnect the stop light switch connector.
(d) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK -- Continue to next step.
6. INSPECT STOP LIGHT SWITCH
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPLACE STOP LIGHT SWITCH See: Lighting and Horns/Brake Light Switch/Service and Repair/Removal
OK -- Continue to next step.
7. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - STOP LIGHT SWITCH)
(a) Make sure that there is no looseness at the locking part and the connecting part of the connector.
No comments:
Post a Comment