INSPECTION PROCEDURE
NOTICE:
When replacing the brake actuator assembly, perform zero point calibration and store system information See: Brakes and
Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Programming and Relearning.
HINT
When DTC C1425 and/or C1426 is output together with DTC C1380, inspect and repair the trouble areas indicated by DTC
C1425 and/or C1426 first See: C1425, or See: C1426).
PROCEDURE
1. CHECK STOP LIGHT OPERATION
(a) Check that the stop lights come on when the brake pedal is depressed, and go off when the brake pedal is released.
OK:
NG -- INSPECT STOP LIGHT CIRCUIT See: Lighting and Horns/Testing and Inspection/Symptom Related Diagnostic
Procedures/Exterior Lighting System
OK -- Continue to next step.
2. READ VALUE USING TECHSTREAM (STOP LIGHT SWITCH)
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Select the Data List on the Techstream See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Data List / Active Test.
No comments:
Post a Comment