(b) Disconnect the clearance warning ECU connector.
Text in Illustration
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE CLEARANCE WARNING ECU BRANCH WIRE OR CONNECTOR (CLEARANCE
WARNING ECU BRANCH WIRE)
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL)
(a) Turn the engine switch on (IG).
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK -- Continue to next step.
4. PERFORM ACTIVE TEST USING HARNESS AND CONNECTOR (GROUND TERMINAL)
(a) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment