(a) Reconnect the CAN No. 3 junction connector.
(b) Measure the resistance according to the value(s) in the table below.
NOTICE:
The resistance must be measured after the main wire connected ECU and junction connector are reconnected.
Standard Resistance:
Text in Illustration
Result:
C -- REPLACE CAN NO. 3 JUNCTION CONNECTOR
B -- REPLACE HEADLIGHT SWIVEL ECU (AFS ECU) See: Lighting and Horns/Headlamp/Headlamp Alignment Control
Module/Service and Repair/Removal
A -- Continue to next step.
11. CHECK FOR SHORT IN CAN NO. 2 BUS WIRE (DRIVING SUPPORT ECU)
(a) Reconnect the driving support ECU connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPLACE DRIVING SUPPORT ECU See: Cruise Control/Cruise Control Module/Service and Repair/Removal
OK -- REPLACE HEADLIGHT SWIVEL ECU (AFS ECU) See: Lighting and Horns/Headlamp/Headlamp Alignment Control
Module/Service and Repair/Removal
No comments:
Post a Comment