(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Test in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE PARKING ASSIST ECU See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist
Systems/Parking Assist Control Module/Service and Repair/Parking Assist ECU/Removal
Up to 08/2009
PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: C1621,C1622: Back Camera Power Supply Failure
DESCRIPTION
This DTC is stored if the parking assist ECU judges as a result of its self check that the signals or signal lines between the parking assist ECU and
the rear television camera assembly are not normal.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
- When "System initializing" is displayed on the multi-display after the battery terminal disconnected, correct the steering angle
neutral point See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Testing and
Inspection/Programming and Relearning/Parking Assist Monitor System/Initialization.
- Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance,
calibration of other systems as well as the parking assist monitor system may be needed See: Accessories and Optional
No comments:
Post a Comment