Text in Illustration
HINT
It is only necessary to perform the inspection in the above table for the result (short circuit) that was obtained in the Check CAN
Bus Wire inspection.
Find the necessary inspection from the Purpose column that matches the result in the Result column from the Check CAN Bus
Wire inspection.
NG -- REPAIR OR REPLACE CAN NO. 2 BUS BRANCH WIRE OR CONNECTOR (CAN NO. 3 J/C - DRIVING
SUPPORT ECU)
OK -- REPLACE DRIVING SUPPORT ECU See: Cruise Control/Cruise Control Module/Service and Repair/Removal
29. CHECK FOR SHORT IN CAN NO. 2 BUS WIRE (4WD CONTROL ECU)
(a) Disconnect the 4WD control ECU connector.
(b) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment