(a) Reconnect the CAN No. 4 junction connector.
(b) Disconnect the CAN No. 5 junction connector.
Text in Illustration
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE CAN BUS MAIN WIRE OR CONNECTOR (CAN NO. 4 J/C - CAN NO. 5 J/C)
OK -- REPLACE CAN NO. 5 JUNCTION CONNECTOR
21. CHECK FOR SHORT IN CAN NO. 2 BUS WIRE (POWER MANAGEMENT CONTROL ECU)
(a) Disconnect the power management control ECU connector.
Text in Illustration
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
HINT
It is only necessary to perform the inspection in the above table for the result (short circuit) that was obtained in the Check CAN
Bus Wire inspection.
Find the necessary inspection from the Purpose column that matches the result in the Result column from the Check CAN Bus
No comments:
Post a Comment