(a) Set the tire pressure to the specified value See: Maintenance/Wheels and Tires/Testing and Inspection/Component Tests and General
Diagnostics.
(b) Turn the engine switch off.
(c) Connect Techstream to the DLC3.
(d) Turn the engine switch on (IG) and turn the tester on.
(e) Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
(f) Check the values by referring to the table below.
Tire Pressure Monitor
HINT
*: It may take about 2 to 3 minutes until the values are displayed. If the values are not displayed after about 2 to 3 minutes,
perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2125/25 See: C Code Charts/C2121.
(g) Rapidly release the pressures from each wheel by approximately 40 kPa (0.4 kgf/cm2, 5.8 psi) within 30 seconds.
(h) Check that each tire pressure data displayed on the Techstream screen has changed.
OK:
Each tire pressure data displayed on the Techstream screen will change to the value of the tire pressure.
NOTICE:
* It takes about 2 to 3 minutes to display the updated tire pressure data.
* When the "ID Tire Inflation Pressure" data has not changed, reset the tire pressure to the appropriate specified value and
rotate the tire 90 to 270锟斤拷(including the spare tire). Then rapidly release the tire pressure and recheck the data.
(i) After confirming that all of the tire pressure data displayed on the Techstream screen has changed, set the tire pressure to the
No comments:
Post a Comment