(b) Make sure that there is no looseness at the locking part and the connecting part of the connectors.
(c) Disconnect the steering angle sensor connector.
(d) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS AND CONNECTOR
OK -- Continue to next step.
3. CHECK WIRE HARNESS (STEERING ANGLE SENSOR - BODY GROUND)
(a) Turn the engine switch off.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS AND CONNECTOR
OK -- REPLACE SPIRAL CABLE (STEERING ANGLE SENSOR) See: Restraints and Safety Systems/Air Bag
Systems/Clockspring Assembly / Spiral Cable/Service and Repair/Removal
From 08/2009
MF1A TRANSFER / 4WD / AWD: ACTIVE TORQUE CONTROL 4WD SYSTEM: C1297: Steering Angle Sensor
C1297 - Steering Angle Sensor
No comments:
Post a Comment