Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (IG CIRCUIT)
OK -- Continue to next step.
3. INSPECT YAW RATE AND ACCELERATION SENSOR (GND TERMINAL)
(a) Turn the engine switch off.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NOTICE:
Check the yaw rate and acceleration sensor signal after replacement See: Brakes and Traction Control/Antilock Brakes /
Traction Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (GND CIRCUIT)
OK -- REPLACE YAW RATE AND ACCELERATION SENSOR See: Brakes and Traction Control/Antilock Brakes / Traction
Control Systems/Acceleration/Deceleration Sensor/Service and Repair/Removal
From 08/2009
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: C0371,C1279: Yaw Rate Sensor
(Test Mode DTC)
DESCRIPTION
DTCs C0371 and C1279 can be cleared when the yaw rate and acceleration sensor sends a yaw rate and/or acceleration signal or when Test Mode
ends. DTCs C0371 and C1279 are output only in Test Mode.
No comments:
Post a Comment