OK:
"OK" is displayed.
HINT
* After selecting "HDD Check", it may take a while until the result is displayed.
* If the cabin temperature is -20锟斤拷C (-4锟斤拷F) or lower, or 65锟斤拷C (149锟斤拷F) or higher, the HDD may not operate normally, and "NG"
may be shown on the display. Make sure to perform the inspection with the cabin at an appropriate temperature.
Text in Illustration
NG -- REPLACE HARD DISK DRIVE See: Accessories and Optional Equipment/Navigation System/Navigation Display/Service
and Repair/Removal and Replacement/Hard Disc Drive/Removal
OK -- Continue to next step.
2. CHECK DTC
(a) Clear the DTC See: Accessories and Optional Equipment/Navigation System/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes/Navigation System (for HDD).
(b) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTC are output.
HINT
The hard disk drive may be malfunctioning even if DTC B15B8 is not output.
NG -- REPLACE HARD DISK DRIVE See: Accessories and Optional Equipment/Navigation System/Navigation Display/Service
and Repair/Removal and Replacement/Hard Disc Drive/Removal
OK -- USE SIMULATION METHOD TO CHECK See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting
From 08/2009
NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM (for HDD): B15B8: Hard disk Malfunction
B15B8 - Hard disk Malfunction
DESCRIPTION
This DTC is stored when the hard disk drive which is built into the display and navigation module display has an initialization malfunction or
read/write errors occur more than a specified number of times.
INSPECTION PROCEDURE
PROCEDURE
1. CHECK HARD DISK DRIVE (OPERATION CHECK)
(a) Enter the "Failure Diagnosis" screen. Refer to Check Hard Disk Drive in Operation Check See: Accessories and Optional
Equipment/Navigation System/Testing and Inspection/Initial Inspection and Diagnostic Overview/Navigation System (for
No comments:
Post a Comment