WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. CHECK HARNESS AND CONNECTOR (MOMENTARY INTERRUPTION)
(a) Using the Techstream, check for any momentary interruption in the wire harness and connector corresponding to the DTC See:
Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Component Tests and General
Diagnostics/Check for Intermittent Problems.
ABS/VSC/TRAC
Result:
HINT
Perform the above inspection before removing the sensor and connector.
C -- REPAIR OR REPLACE HARNESS OR CONNECTOR
B -- RECONFIRM DTC
A -- Continue to next step.
2. CHECK IF EACH SENSOR AND ECM CONNECTOR IS SECURELY CONNECTED
(a) Turn the engine switch off.
(b) Check if each sensor or ECM connector is securely connected.
No comments:
Post a Comment