Text in Illustration
HINT
It is only necessary to perform the inspection in the above table for the result (short circuit) that was obtained in the Check CAN
MS Bus Wire inspection.
Find the necessary inspection from the Purpose column that matches the result in the Result column from the Check CAN MS Bus
Wire inspection.
(c) While observing the resistance value shown on the tester, disconnect branch wire connector (except F74 and F78) from the CAN No. 6
junction connector until the resistance becomes normal (6 kOhms or higher (for +B short) or 200 Ohms or higher (for ground short)).
Text in Illustration
HINT
* The connectors connected to the CAN junction connector can be distinguished by the colors of the bus wire.
* Reconnecting the connectors to non-specified positions on the CAN junction connector does not affect system operation.
Result:
B -- CHECK FOR CAN MS BUS BRANCH WIRE
A -- REPLACE CAN NO. 6 JUNCTION CONNECTOR
16. CHECK FOR CAN MS BUS BRANCH WIRE
No comments:
Post a Comment