2. READ VALUE USING TECHSTREAM (MOTOR ROTATION ANGLE SENSOR)
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG).
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / EMPS / Data List.
(f) Select the item "Motor Rotation Angle" in the Data List and read the value displayed on the Techstream.
EMPS
OK:
During steering operation, motor rotation angle value changes from 0 to 360锟斤拷.
NG -- CHECK STEERING COLUMN ASSEMBLY
OK -- REPLACE POWER STEERING ECU See: Relays and Modules/Relays and Modules - Steering and Suspension/Relays and
Modules - Steering/Steering Control Module/Service and Repair/Removal
3. CHECK STEERING COLUMN ASSEMBLY
(a) Disconnect the connector from the motor rotation angle sensor.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPLACE STEERING COLUMN ASSEMBLY See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Removal and Replacement/Removal
OK -- REPLACE POWER STEERING ECU See: Relays and Modules/Relays and Modules - Steering and Suspension/Relays and
Modules - Steering/Steering Control Module/Service and Repair/Removal
No comments:
Post a Comment