2010 Lexus Truck RX 350 AWD V6-3.5L (2GR-FE) C CODE Page 314

NOTICE:

Check the speed sensor signal after replacement See: Brakes and Traction Control/Antilock Brakes / Traction Control

Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.

NEXT -- Continue to next step.

13. RECONFIRM DTC

(a) Clear the DTCs See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Reading and

Clearing Diagnostic Trouble Codes.

(b) Start the engine.

(c) Drive the vehicle at a speed of 40 km/h (25 mph) or more for at least 60 seconds.

(d) Check if the same DTC is recorded See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and

Inspection/Reading and Clearing Diagnostic Trouble Codes.

Result:

B -- END

A -- REPLACE BRAKE ACTUATOR ASSEMBLY See: Brakes and Traction Control/Antilock Brakes / Traction Control

Systems/Hydraulic Control Assembly - Antilock Brakes/Service and Repair/Removal

Up to 08/2009

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: C0273,C0274,C1361: Open in

ABS Motor Relay Circuit

DESCRIPTION

The ABS motor relay supplies power to the ABS pump motor. While the ABS is activated, the ECU turns the motor relay on and operates the ABS

pump motor.

If the voltage supplied to the motor relay (+BM) is below the DTCs detection threshold due to low voltage from the battery or alternator, these