Result:
HINT
Perform the above inspection before removing the sensor and connector.
C -- REPAIR OR REPLACE HARNESS OR CONNECTOR
B -- RECONFIRM DTC
A -- Continue to next step.
2. CHECK IF EACH SENSOR AND ECM CONNECTOR IS SECURELY CONNECTED
(a) Turn the engine switch off.
(b) Check if each sensor or ECM connector is securely connected.
OK:
Each connector is securely connected.
NG -- CONNECT CONNECTOR TO EACH SENSOR OR ECM CORRECTLY
OK -- Continue to next step.
3. RECONFIRM DTC
(a) Turn the engine switch off.
(b) Record the output DTCs (for ABS, VSC system and/or CAN communication system) See: Brakes and Traction Control/Antilock
Brakes / Traction Control Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes for ABS and VSC system,
or See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Initial Inspection and
Diagnostic Overview/CAN Communication System/Diagnosis System for CAN communication system).
HINT
If CAN communication system DTCs and the relevant sensor DTCs are output simultaneously, troubleshoot the relevant sensor
DTCs (for ABS and/or VSC system) after the CAN communication system returns to normal.
Result:
C -- INSPECT CAN COMMUNICATION SYSTEM See: Powertrain Management/Computers and Control Systems/Information
Bus/Testing and Inspection/Initial Inspection and Diagnostic Overview/CAN Communication System/How to Proceed With
Troubleshooting
B -- REPAIR CIRCUIT INDICATED BY OUTPUT DTC See: Diagnostic Trouble Code Descriptions/Vehicle Stability Control
No comments:
Post a Comment