(c) Disconnect the cable from the negative (-) battery terminal.
(d) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
Result:
D -- CHECK FOR SHORT IN CAN BUS WIRES (POWER MANAGEMENT CONTROL ECU)
C -- CHECK FOR SHORT IN CAN MS BUS WIRE (POWER MANAGEMENT CONTROL ECU)
B -- CHECK FOR OPEN IN CAN BUS WIRE (POWER MANAGEMENT CONTROL ECU)
A -- REPLACE POWER MANAGEMENT CONTROL ECU See: Power and Ground Distribution/Power Distribution
Module/Service and Repair/Removal
2. CHECK FOR OPEN IN CAN BUS WIRE (POWER MANAGEMENT CONTROL ECU)
(a) Disconnect the power management control ECU connector.
Text in Illustration
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- CHECK FOR OPEN IN CAN BUS WIRE (ECM)
OK -- REPLACE POWER MANAGEMENT CONTROL ECU See: Power and Ground Distribution/Power Distribution
Module/Service and Repair/Removal
3. CHECK FOR OPEN IN CAN BUS WIRE (ECM)
No comments:
Post a Comment