NG -- REPLACE REAR TELEVISION CAMERA ASSEMBLY See: Accessories and Optional Equipment/Camera/Rear Vision
Camera/Service and Repair/Removal
OK -- REPLACE PARKING ASSIST ECU See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist
Systems/Parking Assist Control Module/Service and Repair/Parking Assist ECU/Removal
Up to 08/2009
PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: C1625: Open or Short in Steering Angle Sensor +B
C1625 - Open or Short in Steering Angle Sensor +B
DESCRIPTION
This DTC is stored if the parking assist ECU receives a signal via CAN communication from the spiral with sensor cable sub-assembly that indicates
a power supply system problem.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
- When "System initializing" is displayed on the multi-display after the battery terminal disconnected, correct the steering angle
neutral point See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Testing and
Inspection/Programming and Relearning/Parking Assist Monitor System/Initialization.
- Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance,
calibration of other systems as well as the parking assist monitor system may be needed See: Accessories and Optional
Equipment/Collision Avoidance and Parking Assist Systems/Testing and Inspection/Programming and Relearning/Parking
Assist Monitor System/Calibration.
PROCEDURE
1. CHECK HARNESS AND CONNECTOR (SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY POWER SUPPLY)
(a) Disconnect the F43 connector from the spiral with sensor cable sub-assembly.
(b) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment