OK -- Continue to next step.
4. CHECK FOR OPEN IN CAN BUS MAIN WIRE (CAN NO. 6 J/C - MAIN BODY ECU)
(a) Disconnect the CAN No. 6 junction connector.
Text in Illustration
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- CHECK FOR OPEN IN CAN BUS MAIN WIRE (MAIN BODY ECU)
OK -- REPLACE CAN NO. 6 JUNCTION CONNECTOR
5. CHECK FOR OPEN IN CAN BUS MAIN WIRE (MAIN BODY ECU)
(a) Reconnect the CAN No. 6 junction connectors.
(b) Disconnect the main body ECU connector.
Text in Illustration
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE CAN MS BUS MAIN WIRE OR CONNECTOR (CAN NO. 6 J/C - MAIN BODY ECU)
OK -- REPLACE MULTIPLEX NETWORK BODY ECU (MAIN BODY ECU) See: Power and Ground Distribution/Power
Distribution Module/Service and Repair/Removal
6. CHECK FOR SHORT IN CAN MS BUS WIRES (TILT AND TELESCOPIC ECU)
(a) Disconnect the tilt and telescopic ECU connector.
No comments:
Post a Comment