NG -- REPLACE NO. 2 FLOOR WIRE
OK -- Continue to next step.
6. CHECK FRONT SEAT INNER BELT ASSEMBLY LH
(a) Connect the connectors to the center airbag sensor assembly and front seat inner belt assembly LH.
(b) Connect the cable to the negative (-) battery terminal.
(c) Turn the engine switch on (IG), and wait for at least 60 seconds.
(d) Clear the DTCs stored in the memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes/DTC Check / Clear.
(e) Turn the engine switch off.
(f) Turn the engine switch on (IG), and wait for at least 60 seconds.
(g) Check for DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
OK:
DTC B1656/38 is not output.
Text in Illustration
HINT
Codes other than DTC B1656/38 may be output at this time, but they are not related to this check.
NG -- REPLACE FRONT SEAT INNER BELT ASSEMBLY LH
OK -- USE SIMULATION METHOD TO CHECK See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting
7. REPLACE FRONT SEAT INNER BELT ASSEMBLY LH
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Replace the front seat inner belt assembly LH with a known good part See: Restraints and Safety Systems/Seat Belt Systems/Seat
Belt/Service and Repair/Removal and Replacement/Front Seat Inner Belt Assembly/Removal.
HINT
Perform the following inspection using known good parts from another vehicle if possible.
No comments:
Post a Comment