HINT
The CAN communication system must be normal when performing troubleshooting for each sensor DTC (for ABS and/or VSC
system).
C -- INSPECT CAN COMMUNICATION SYSTEM See: Powertrain Management/Computers and Control Systems/Information
Bus/Testing and Inspection/Initial Inspection and Diagnostic Overview/CAN Communication System/How to Proceed With
Troubleshooting
B -- REPAIR CIRCUIT INDICATED BY OUTPUT DTC See: Diagnostic Trouble Code Descriptions/Vehicle Stability Control
System
A -- END
Up to 08/2009
NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM (for DVD): U0073,U0155,U0164,U1110: Control Module
Communication Bus Off
U1110 - Lost Communication with Clearance Warning ECU
DESCRIPTION
These DTCs are stored when a CAN communication circuit malfunction is detected by display and navigation module display self check.
INSPECTION PROCEDURE
PROCEDURE
1. CHECK DTC
(a) Clear the DTCs See: Accessories and Optional Equipment/Navigation System/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes/Navigation System (for DVD).
(b) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
NG -- GO TO CAN COMMUNICATION SYSTEM See: Powertrain Management/Computers and Control Systems/Information
Bus/Testing and Inspection/Initial Inspection and Diagnostic Overview/CAN Communication System/How to Proceed With
Troubleshooting
OK -- USE SIMULATION METHOD TO CHECK See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting
From 08/2009
NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM (for DVD): U0073,U0155,U0164,U1110: Control Module
Communication Bus Off
U1110 - Lost Communication with Clearance Warning ECU
No comments:
Post a Comment