(d) Check that the stop light switch display and brake pedal load sensing switch display observed on the Techstream change according to
brake pedal operation.
OK:
The Techstream displays ON or OFF according to brake pedal operation.
(e) Slowly depress the brake pedal, and check when the stop light switch and brake pedal load sensing switch turn ON.
OK:
First the stop light switch should turn ON, and then the brake pedal load sensing switch should turn ON.
Result:
C -- CHECK BRAKE PEDAL AND STOP LIGHT SWITCH INSTALLATION
B -- INSPECT BRAKE PEDAL LOAD SENSING SWITCH
A -- Continue to next step.
2. RECONFIRM DTC
(a) Turn the engine switch off.
(b) Clear the DTCs See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes.
(c) Start the engine.
(d) Perform the road test.
(e) Check if the same DTC is recorded See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes.
Result:
B -- REPLACE BRAKE ACTUATOR ASSEMBLY See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Hydraulic Control Assembly - Antilock Brakes/Service and Repair/Removal
A -- CHECK FOR INTERMITTENT PROBLEMS See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting
3. INSPECT BRAKE PEDAL LOAD SENSING SWITCH
No comments:
Post a Comment