- If the rear speed sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.
B -- CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - EACH SPEED SENSOR)
A -- CLEAN OR REPLACE EACH SPEED SENSOR ROTOR
4. CHECK HARNESS AND CONNECTOR (SKID CONTROL SENSOR WIRE)
(a) Make sure that there is no looseness at the locking part and the connecting part of the connectors.
(b) Disconnect the skid control sensor wire.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for RH
for LH
NOTICE:
Check the speed sensor signal after replacement See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.
No comments:
Post a Comment