NG -- INSPECT AIR MIX CONTROL SERVO MOTOR
OK -- REPLACE A/C AMPLIFIER
3. INSPECT AIR MIX CONTROL SERVO MOTOR
(a) Replace the air mix control servo motor See: Heating and Air Conditioning/Housing Assembly HVAC/Service and
Repair/Overhaul/Disassembly.
HINT
Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a new or a known
good one and check that the condition returns to normal.
(b) Check for the DTC.
Result:
B -- END (AIR MIX CONTROL SERVO MOTOR WAS DEFECTIVE)
A -- Continue to next step.
1. INSPECT AIR CONDITIONING HARNESS
(a) Replace the air conditioning harness See: Heating and Air Conditioning/Housing Assembly HVAC/Service and
Repair/Overhaul/Disassembly.
HINT
Since the air conditioning harness cannot be inspected while it is removed from the vehicle, replace the air conditioning harness
with a new or a known good one and check that the condition returns to normal.
(b) Check for the DTC.
Result:
B -- END (AIR CONDITIONING HARNESS WAS DEFECTIVE)
A -- REPLACE A/C AMPLIFIER
Up to 08/2009
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING SYSTEM: C2141/41-C2145/45: Transmitter ID1 Error
C2145/45 - Transmitter ID5 Error
DESCRIPTION
The tire pressure warning valve and transmitters that are installed in the tire and wheel assemblies measure the tire pressure. The measured values are
transmitted to the tire pressure warning antenna and receiver on the body as radio waves and then sent to the tire pressure warning ECU. The ECU
compares the measured air pressure values with the air pressure threshold. When the measured air pressure value is less than this threshold, the
warning light in the combination meter turns on.
When the internal circuit of a tire pressure warning valve and transmitter is malfunctioning, one of these DTCs will be output.
No comments:
Post a Comment