(b) Disconnect the skid control ECU connector and the stop light switch connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
8. RECONFIRM DTC
(a) Reconnect the skid control ECU connector and the stop light switch connector.
(b) Clear the DTCs See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes.
(c) Start the engine.
(d) Depress the brake pedal several times to test the stop light circuit.
(e) Check if the same DTC is recorded See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes.
Result:
HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next
step See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Symptom Related
Diagnostic Procedures/Problem Symptoms Table.
B -- REPLACE BRAKE ACTUATOR ASSEMBLY See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Hydraulic Control Assembly - Antilock Brakes/Service and Repair/Removal
A -- INSPECT LIGHTING SYSTEM (STOP LIGHT CIRCUIT) See: Lighting and Horns/Testing and Inspection/Symptom
Related Diagnostic Procedures/Exterior Lighting System
No comments:
Post a Comment