(d) w/o Navigation System:
(1) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- CHECK INSTRUMENT PANEL WIRE (SHORT TO B+)
OK -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY See: Relays and Modules/Relays and Modules - Restraints and
Safety Systems/Air Bag Control Module/Service and Repair/Removal
9. CHECK CONNECTORS
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Check that the connectors are properly connected to the center airbag sensor assembly and radio receiver assembly*1 or accessory
meter assembly*2. Also check that the connectors that link the instrument panel wire and No. 2 instrument panel wire are properly
connected.
*1: w/ Navigation System
*2: w/o Navigation System
OK:
The connectors are properly connected.
HINT
If the connectors are not connected securely, reconnect the connectors and proceed to the next inspection.
(d) Disconnect the connectors from the center airbag sensor assembly and radio receiver assembly*1 or accessory meter assembly*2. Also
No comments:
Post a Comment