(b) Make sure that there is no looseness at the locking part and the connecting part of the connectors.
(c) Disconnect the skid control ECU connector and the stop light switch connector.
(d) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next
step See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Symptom Related
Diagnostic Procedures/Problem Symptoms Table.
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE BRAKE ACTUATOR ASSEMBLY See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Hydraulic Control Assembly - Antilock Brakes/Service and Repair/Removal
10. CHECK BRAKE PEDAL AND STOP LIGHT SWITCH INSTALLATION
(a) Turn the engine switch off.
(b) Check the brake pedal height and stop light switch installation See: Brakes and Traction Control/Brake Pedal Assy/Service and
Repair/Removal and Replacement/Installation.
OK:
The brake pedal height and stop light switch installation are normal.
HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next
step See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Symptom Related
Diagnostic Procedures/Problem Symptoms Table.
NG -- ADJUST BRAKE PEDAL OR STOP LIGHT SWITCH See: Brakes and Traction Control/Brake Pedal Assy/Adjustments
OK -- REPLACE BRAKE PEDAL SUB-ASSEMBLY (BRAKE PEDAL LOAD SENSING SWITCH) See: Brakes and Traction
Control/Brake Pedal Assy/Service and Repair/Removal and Replacement/Removal
Up to 08/2009
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: C1427: Motor Malfunction
C1427 - Motor Malfunction
No comments:
Post a Comment