and Inspection/Programming and Relearning/Initialization after registration See: Instrument Panel, Gauges and Warning
Indicators/Tire Monitoring System/Testing and Inspection/Programming and Relearning/Registration of the transmitter IDs into
the tire pressure warning ECU if the ECU and/or any of the valve and transmitters have been replaced.
PROCEDURE
1. PERFORM FORCED TRANSMISSION OF TRANSMITTER ID OF ALL WHEELS
(a) Set the tire pressure to the specified value See: Maintenance/Wheels and Tires/Testing and Inspection/Component Tests and General
Diagnostics.
(b) Turn the engine switch off.
(c) Connect Techstream to the DLC3.
(d) Turn the engine switch on (IG) and turn the tester on.
(e) Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
(f) Check the values by referring to the table below.
Tire Pressure Monitor
HINT
*: It may take about 2 to 3 minutes until the values are displayed. If the values are not displayed after about 2 to 3 minutes,
perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2125/25 See: C Code Charts/C2121.
(g) Rapidly release the pressures from each wheel by approximately 40 kPa (0.4 kgf/cm2, 5.8 psi) within 30 seconds.
(h) Check that each tire pressure data displayed on the Techstream screen has changed.
No comments:
Post a Comment