Result:
HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next
step See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Symptom Related
Diagnostic Procedures/Problem Symptoms Table.
B -- REPLACE BRAKE ACTUATOR ASSEMBLY See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Hydraulic Control Assembly - Antilock Brakes/Service and Repair/Removal
A -- CHECK FOR INTERMITTENT PROBLEMS See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting
4. INSPECT STOP FUSE
(a) Remove the STOP fuse from the engine room relay block.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPLACE STOP FUSE
OK -- Continue to next step.
5. INSPECT STOP LIGHT SWITCH (POWER SOURCE TERMINAL)
(a) Install the STOP fuse.
(b) Make sure that there is no looseness at the locking part and the connecting part of the connectors.
(c) Disconnect the stop light switch connector.
(d) Measure the voltage according to the value(s) in the table below.
No comments:
Post a Comment