4. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BRAKE PEDAL LOAD SENSING SWITCH)
(a) Make sure that there is no looseness at the locking part and the connecting part of the connector.
(b) Disconnect the skid control ECU connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE BRAKE ACTUATOR ASSEMBLY See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Hydraulic Control Assembly - Antilock Brakes/Service and Repair/Removal
5. CHECK BRAKE PEDAL AND STOP LIGHT SWITCH INSTALLATION
(a) Turn the engine switch off.
(b) Check the brake pedal height and stop light switch installation See: Brakes and Traction Control/Brake Pedal Assy/Service and
Repair/Removal and Replacement/Installation.
OK:
The brake pedal height and stop light switch installation are normal.
NG -- ADJUST BRAKE PEDAL OR STOP LIGHT SWITCH See: Brakes and Traction Control/Brake Pedal Assy/Adjustments
OK -- REPLACE BRAKE PEDAL SUB-ASSEMBLY (BRAKE PEDAL LOAD SENSING SWITCH) See: Brakes and Traction
Control/Brake Pedal Assy/Service and Repair/Removal and Replacement/Removal
Up to 08/2009
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: C1430,C1431: Brake Pedal
Load Sensing Switch OFF Stuck Malfunction
No comments:
Post a Comment