(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
(c) Check that the connectors are properly connected to the 4 occupant classification sensors and occupant classification ECU.
OK:
The connectors are properly connected.
HINT
If the connectors are not connected securely, reconnect the connectors and proceed to the next inspection.
(d) Disconnect the connectors from the 4 occupant classification sensor and occupant classification ECU.
(e) Check that the terminals of connectors are not damaged.
OK:
The terminals are not deformed or damaged.
NG -- REPLACE FRONT SEAT WIRE RH
OK -- Continue to next step.
2. CHECK FRONT SEAT WIRE RH (SHORT TO B+)
(a) Connect the cable to the negative (-) battery terminal.
(b) Turn the engine switch on (IG).
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- REPLACE FRONT SEAT WIRE RH
OK -- Continue to next step.
3. CHECK FRONT SEAT WIRE RH (SHORT TO GROUND)
(a) Turn the engine switch off.
No comments:
Post a Comment