B -- CHECK HARNESS AND CONNECTOR
A -- Continue to next step.
4. CHECK HARNESS AND CONNECTOR
(a) Disconnect the O15 stereo component amplifier assembly connector.
(b) Disconnect the G6 display and navigation module display connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
5. REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY
(a) Replace the stereo component amplifier assembly See: Accessories and Optional Equipment/Radio, Stereo, and Compact
Disc/Amplifier/Service and Repair/Removal.
(b) Clear the DTCs See: Accessories and Optional Equipment/Navigation System/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes/Navigation System (for HDD).
(c) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
NG -- REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY See: Accessories and Optional Equipment/Navigation
System/Service and Repair/Navigation Receiver (for HDD)/Removal
OK -- END
1. CHECK HARNESS AND CONNECTOR
(a) Disconnect the O15 stereo component amplifier assembly connector.
No comments:
Post a Comment