or if the knob is stuck, preventing the remote touch from completing knob position initialization.
INSPECTION PROCEDURE
NOTICE:
* When there are any foreign objects around the remote touch switch knob that interfere with knob operation, or if the knob is
stuck during the initial check, the remote touch cannot initialize the knob position.
* When there is a foreign object near the remote touch switch knob that interferes with knob operation, or if the knob is stuck,
remove the foreign object or free the knob before performing the following inspection. After removing the object or freeing
the knob, move the knob to allow it to perform its initial check again See: Accessories and Optional Equipment/Navigation
System/Testing and Inspection/Initial Inspection and Diagnostic Overview/Navigation System (for HDD)/Operation Check.
PROCEDURE
1. CHECK DTC
(a) Clear the DTCs See: Accessories and Optional Equipment/Navigation System/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes/Navigation System (for HDD).
(b) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
NG -- REPLACE REMOTE OPERATION BOARD See: Accessories and Optional Equipment/Navigation System/Navigation
Display/Service and Repair/Removal and Replacement/Multi Info Display/Removal
OK -- END
Up to 08/2009
NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM (for DVD): B1582: Map Disk Reading Malfunction
B1582 - Map Disk Reading Malfunction
DESCRIPTION
This DTC is stored when the multi-media module navigation assembly cannot read the map disc.
INSPECTION PROCEDURE
PROCEDURE
1. CHECK MAP DISC
(a) Check that the map disc is not deformed or cracked.
OK:
No deformations or cracks on the map disc
No comments:
Post a Comment