NG -- REPLACE A/C AMPLIFIER
OK -- Continue to next step.
2. INSPECT A/C AMPLIFIER
(a) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- REPLACE A/C AMPLIFIER
OK -- REPLACE AIR CONDITIONING HARNESS See: Heating and Air Conditioning/Housing Assembly HVAC/Service and
Repair/Overhaul/Disassembly
Up to 08/2009
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING SYSTEM: C2111/11-C2115/15: Transmitter ID1 Operation Stop
C2115/15 - Transmitter ID5 Operation Stop
DESCRIPTION
The tire pressure warning valve and transmitters that are installed in the tire and wheel assemblies measure the tire pressures. The measured values
are transmitted to the tire pressure warning antenna and receiver on the body as radio waves and then sent to the tire pressure warning ECU. The
ECU compares the measured air pressure values with the air pressure threshold. When the measured air pressure value is less than this threshold, the
warning light in the combination meter comes on. The tire pressure warning ECU stores a DTC when the tire pressure warning valve and transmitter
stops transmitting signals. At this time, forcibly transmit the signals by releasing the tire pressure rapidly. The stored DTC is cleared when the signal
transmission is resumed.
HINT
It is necessary to perform the procedure to identify the tire pressure warning valve and transmitter that is malfunctioning because
it cannot be identified by the output DTC.
INSPECTION PROCEDURE
NOTICE:
It is necessary to perform initialization See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Testing
No comments:
Post a Comment