(b) Remove the steering wheel and the column cover lower.
(c) Make sure that there is no looseness at the locking part and the connecting part of the connector.
(d) Disconnect the steering angle sensor connector.
(e) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK -- Continue to next step.
3. INSPECT STEERING ANGLE SENSOR (GROUND TERMINAL)
(a) Turn the engine switch off.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next
step See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Symptom Related
Diagnostic Procedures/Problem Symptoms Table.
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT)
OK -- REPLACE SPIRAL CABLE (STEERING ANGLE SENSOR) See: Brakes and Traction Control/Antilock Brakes /
Traction Control Systems/Steering Angle Sensor/Service and Repair/Removal
No comments:
Post a Comment