Standard Resistance:
(c) Reconnect the front seat outer belt assembly LH connector.
NG -- REPLACE FRONT SEAT OUTER BELT ASSEMBLY LH See: Restraints and Safety Systems/Seat Belt Systems/Seat
Belt/Service and Repair/Removal and Replacement/Front Seat Outer Belt Assembly/Removal
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (FRONT SEAT OUTER BELT ASSEMBLY LH - SEAT BELT CONTROL ECU)
(a) Disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(b) Disconnect the front seat outer belt assembly LH connector.
(c) Disconnect the seat belt control ECU connector.
(d) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
(e) Reconnect the front seat outer belt assembly LH and seat belt control ECU connectors.
(f) Connect the cable to the negative (-) battery terminal.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (FRONT SEAT OUTER BELT ASSEMBLY LH - SEAT
BELT CONTROL ECU)
OK -- REPLACE SEAT BELT CONTROL ECU See: Restraints and Safety Systems/Seat Belt Systems/Seat Belt/Service and
Repair/Removal and Replacement/Front Seat Outer Belt Assembly/Removal
From 08/2009
PRE-COLLISION: PRE-COLLISION SYSTEM: B2006: Short to GND in Seat Belt Motor LH Circuit
B2006 - Short to GND in Seat Belt Motor LH Circuit
DESCRIPTION
The seat belt control ECU receives information from the driving support ECU using CAN communication and tightens the seat belt by operating the
motor in the front seat outer belt assembly LH.
No comments:
Post a Comment