NOTICE:
- Do not remove the brake pedal load sensing switch from the brake pedal sub-assembly.
- When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal sub-assembly.
(a) Turn the engine switch off.
(b) Make sure that there is no looseness at the locking part and the connecting part of the connector.
(c) Disconnect the brake pedal load sensing switch connector.
(d) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPLACE BRAKE PEDAL SUB-ASSEMBLY (BRAKE PEDAL LOAD SENSING SWITCH) See: Brakes and Traction
Control/Brake Pedal Assy/Service and Repair/Removal and Replacement/Removal
OK -- Continue to next step.
4. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BRAKE PEDAL LOAD SENSING SWITCH)
(a) Make sure that there is no looseness at the locking part and the connecting part of the connector.
(b) Disconnect the skid control ECU connector.
(c) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment