(e) Read the DTCs using the Techstream.
Result:
HINT
If a solenoid is stuck ON, DTCs for several solenoids including the malfunctioning solenoid will be detected.
A -- INSPECT SHIFT SOLENOID VALVE SLT
B -- Continue to next step.
2. PERFORM ACTIVE TEST USING TECHSTREAM (SHIFT SOLENOID VALVE SLT)
NOTICE:
- Perform the test at the normal operating ATF (Automatic Transmission Fluid) temperature: 50 to 80锟斤拷C (122 to 176锟斤拷F)
- Be sure to prevent SST hose from interfering with the exhaust pipe.
- This check must be conducted after checking and adjusting the engine.
- Perform the test with the A/C OFF.
HINT
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing
any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before
parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List
information can be displayed while performing Active Tests.
(a) Turn the engine switch off.
(b) Lift the vehicle up.
(c) Remove the test plug on the transmission case center right side and connect SST.
SST : 09992-00095
09992-00231
09992-00271
(d) Lower the vehicle.
(e) Fully apply the parking brake and chock the 4 wheels.
(f) Connect the Techstream to the DLC3.
(g) Start the engine.
(h) Warm up the Automatic Transmission Fluid (ATF).
(i) Measure the line pressure when the engine is idling.
(j) Turn the Techstream on.
(k) Enter the following menus: Powertrain / ECT / Active Test.
(l) Follow the instructions on the Techstream and perform the Active Test.
No comments:
Post a Comment