2010 Lexus Truck RX 350 AWD V6-3.5L (2GR-FE) P Code Charts Page 2040

- Connect the Techstream to the DLC3.

- Turn the engine switch on (IG).

- Turn the Techstream on.

- Enter the following menus: Powertrain / ECT / Data List.

- According to the display on the Techstream, read the Data List.

TCM

HINT

- SPD (NT) is always 0 while driving: Open or short in the sensor or circuit.

- SPD (NT) is always more than 0 and less than 300 rpm while driving the vehicle at 50 km/h (31 mph) or more: Sensor trouble,

improper installation, or intermittent connection trouble of the circuit.

PROCEDURE

1. INSPECT SPEED SENSOR (SENSOR INSTALLATION)

(a) Remove the valve body assembly.

(b) Make sure that the connector is properly connected, and check the speed sensor installation.

OK:

The installation bolt is tightened properly and there is no clearance between the sensor and transaxle case.

NG -- REPAIR OR REPLACE SPEED SENSOR See: Powertrain Management/Transmission Control Systems/Sensors and

Switches - Transmission and Drivetrain/Sensors and Switches - A/T/Transmission Speed Sensor/Service and Repair/U660E Automatic

Transaxle/Removal

OK -- Continue to next step.

2. INSPECT TRANSMISSION WIRE