Text in Illustration
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
HINT
It is only necessary to perform the inspection in the above table for the result (open or short circuit) that was obtained in the
Check CAN Bus Wire inspection.
Find the necessary inspection from the Purpose column that matches the result in the Result column from the Check CAN Bus
Wire inspection.
NG -- CHECK FOR SHORT IN CAN BUS WIRES (CAN NO. 7 J/C MAIN WIRE)
OK -- REPLACE ECM See: Powertrain Management/Computers and Control Systems/Engine Control Module/Service and
Repair/Removal
11. CHECK FOR SHORT IN CAN BUS WIRES (CAN NO. 7 J/C MAIN WIRE)
(a) Disconnect the CAN No. 7 junction connector.
Text in Illustration
(b) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment