Standard Voltage:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK -- Continue to next step.
4. CHECK HARNESS AND CONNECTOR (GROUND TERMINAL)
(a) Disconnect the ECM connector.
Text in Illustration
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT)
OK -- REPLACE ECM See: Powertrain Management/Computers and Control Systems/Engine Control Module/Service and
Repair/Removal
From 08/2009
NETWORKING: CAN COMMUNICATION SYSTEM: U0100: Lost Communication with ECM / PCM
U0100 - Lost Communication with ECM / PCM
No comments:
Post a Comment