(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NOTICE:
Check the yaw rate and acceleration sensor signal after replacement See: Brakes and Traction Control/Antilock Brakes /
Traction Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (GND CIRCUIT)
OK -- REPLACE YAW RATE AND ACCELERATION SENSOR See: Brakes and Traction Control/Antilock Brakes / Traction
Control Systems/Acceleration/Deceleration Sensor/Service and Repair/Removal
From 08/2009
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: C0371,C1279: Yaw Rate Sensor
(Test Mode DTC)
DESCRIPTION
DTCs C0371 and C1279 can be cleared when the yaw rate and acceleration sensor sends a yaw rate and/or acceleration signal or when Test Mode
ends. DTCs C0371 and C1279 are output only in Test Mode.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
When replacing the yaw rate and acceleration sensor, perform zero point calibration See: Brakes and Traction Control/Antilock
No comments:
Post a Comment